Wolf Rangetop CLK-CONT Error: Keeps Clicking After Lit
What Does Wolf Rangetop Continuous Clicking Mean? On a Wolf Sealed Burner Rangetop, the spark module is supposed to click only while the burner is being lit. Once ignition succeeds, the module senses the flame and stops clicking. When the clicking continues after the flame is clearly established — sometimes for the entire cooking session […]
Quick Assessment
Answer to continue safely
Is it safe to keep using?
Yes. Continuous clicking is a cosmetic annoyance rather than a safety issue — the burner is producing normal heat and the clicking does not affect cooking. Using the rangetop while the condition is present is fine. Schedule service at your convenience.
Can I reset the code?
No. This is a sensing issue, not an electronic state that can be reset. Drying and cleaning are the only homeowner remedies.
When to stop immediately?
Stop if you notice: Clicking continues after thorough drying and cleaning, The clicking is accompanied by any gas smell.
Symptoms You May Notice
Clicking continues after the burner is lit
A burner lights normally but the spark module keeps audibly clicking at regular intervals throughout the cook rather than stopping once the flame is established.
Multiple burners may click together
The spark module drives all electrodes simultaneously, so on many Wolf rangetops, clicking one burner that fails to confirm ignition will cause every burner to keep clicking.
Clicking stops temporarily after drying the burner area
A brief pause in clicking when the burner area is dried suggests the issue is moisture-related.
Possible Causes
Moisture on or around the burner electrode
Water from a boil-over, a spill, or overly damp cleaning has reached the electrode and is creating a short to ground that the module reads as an ignition failure.
DIY PossibleDirty or contaminated ignition electrode
Accumulated grease, food residue, or mineral deposits on the electrode are preventing clean spark detection and confirmation.
DIY PossibleBurner cap misaligned or not seated
A cap that is not square on the base is keeping the flame from reaching the sensing area of the electrode.
DIY PossibleSpark module or flame-sense circuit fault
The electronic module has a fault in its flame-sensing circuit and cannot recognize a lit burner even under ideal conditions.
Requires ProfessionalSafe Checks You Can Do
-
1
Dry the burner area completely
Turn every burner off. Remove the burner caps and dry the burner base, electrode, and surrounding drip area with a clean dry towel. Let the area air-dry for an additional 10 minutes before replacing the caps.
Moisture is the single most common cause of continuous clicking — especially after heavy cleaning or a boil-over.
-
2
Clean the electrode tip gently
With the burner cool and disassembled, wipe the electrode tip with a clean dry cloth. Do not use solvents or abrasives.
Only clean what you can reach without tools — the electrode base is not a service point.
-
3
Reseat the burner cap square
Replace the burner cap, making sure it drops fully into the keyed position. Test the burner at Low first to see if the clicking stops once a small flame is established.
If the clicking stops at Low but returns at High, the flame-sense position is marginal and needs a technician.
When to Call a Professional
Contact a qualified technician if:
- Continuous clicking started after a deep rangetop cleaning
- Clicking is accompanied by intermittent flame issues
- Electrode shows visible discoloration or corrosion
Need Professional Help?
Find qualified technicians in your area for proper diagnostics and repair.
Rangetop Repair Service Schedule Appointment